Intermatic HomeSettings HA07C Zwave Master Remote Controller
- Use to assign ID codes to all Z-Wave devices - Programs Z-Wave components quickly and easily - 12 Programmable channels control up to 16 devices each up to 192 devices - Features: ALL ON/ALL OFF, timing functions, 2-way feedback, low battery indicator - Use with HomeSeer Pro or HomeSeer HS2 Home Control Software and a PC interface to add devices to HomeSeer (not required for Z-Troller) - Use with Z-Troller as a secondary controller to manually control your devices - Works as a Primary or Secondary Z-Wave remote - Supports Z-Wave lighting and appliance devices, does not support direct control of Z-Wave thermostats or other Z-Wave devices. (although they may be added to the remote for use by HomeSeer)
|
The HA07 Master Remote Controller is a Z-Wave™ enabled device and is fully compatible with any Home Settings network and any ZWave™ enabled network. Z-Wave™ enabled devices displaying the Z-Wave™ logo can also be used with Home Settings modules and controllers regardless of the manufacturer, and Home Settings modules and controllers can also be used in other manufacturer’s ZWave™ enabled networks. Each module in a Home Settings network is designed to act as a repeater. Repeaters can re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.
The HA07 Controller also includes the following features: time changes.
Use this tabletop remote control to control your Z-Wave devices remotely. Each button on the remote can be used to control one, or many devices. Tap a button to turn a device(s) on or off, or hold down a button to bright/dim a device. Set a group of devices to different light levels, or "scenes". The controller may be used stand-alone as it contains its own timers, or used with HomeSeer Pro or HomeSeer HS2 Home Control Software for advanced control. HomeSeer requires at least one remote when used with most Z-Wave PC interfaces, except the Z-Troller. Note: When using the HA22 PC Interface, use the channel 2 button, not the channel 1 button when copying device information to HomeSeer |