Your shopping cart is currently empty. Please continue shopping - as there is nothing to check out
|
- Z-Wave Frequency: 908.42 MHz (US) - Indoor use only - Requires HomeSeer 2.5.0.60 or later - CR2 Battery - Double-stick Tape - Mounting Screws - User Guide
|
|
The HSP02 is designed to control Z-Wave devices based on motion and light level. Example: Use to turn on lights when a dark room is entered. The unit can also report motion sensed to HomeSeer and other control systems. Note: Light level is used by the unit to regulate when motion sensed is reported; it does not report light level to control systems. You can set a threshold where the motion sensor is disable if the light level is above a specific level. To set this, click on the device name on the status page for the root device, then click on the Configure button. The sensor must be awake. To wake it, remove the back cover and press the tamper switch 3 times quickly. The sensor will stay awake for about 4 seconds. You will need to do this before modifying any settings. Note: When adding this to your HomeSeer system, use the Add Node button on the Z-Wave manage page. The sensor must be awake in order to add it. Remove the rear cover and press the tamper switch 3 times quickly, then click the Add Node button. The sensor will then be included. You can then install the sensor at its final location. Once installed, again wake the sensor and press the Optimize Node button in the device properties (click on the name of the device on the HomeSeer status page). Note that the sensor only stays awake for a few seconds after pressing the tamp switch 3 times. If the sensor does not add, try removing it first using the Remove Node button. |
