Evolve LFM-20 - 20A Z-Wave Relay Fixture Module

- The relay on this device is isolated from the power line, so it can be used to switch any load, including low voltage. This can be used in areas where an X10 universal module may have been used.

- The LED on the LFM-20 will turn on when the load attached is ON. The LED is user configured however to turn ON when the load attached is OFF, if so desired.

- The LFM-20 supports the AS101 and AS001 auxiliary switch.

- Max load 20 amps.

- Supports Z-Wave 40Kbps speed

- Signal (Frequency): 908.42 MHz 

Evolve LFM-20 Manual

The  LFM-20 Isolated Contact Fixture Module is a component of the Evolve lighting control system. Wire the Isolated Contact Fixture Module according to the diagram above and program it from the Wireless Controller to operate loads. Inclusion of this Switch on the ZTH100 Wireless Controller menu allows remote ON/OFF control of load connected. This Isolated Contact Fixture Module is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types can be included on the network and will also act as repeaters if they support this function. As part of a Z-Wave network, the LFM-20 will also act as a wireless repeater to insure that commands intended for another device in the network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller.

There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where purchased