ACT PCC RB204 A10, 240 VAC, 50/60 Hz, 30A, Box Mount Receiver

- X10 Standard Code (256 Addresses) and X10 compatible Extended Addressing capability (4096 addresses)

- Two way powerline communication, reports status upon "Status Request" for standard or extended addresses

- Easy Push Button Configuring for Standard Unit Address ON/OFF and:

- Advanced A10 circuitry, X10 Signal Compatible

- On/Off/Auto Switch on Cover

- Terminals inside for connection of remote override switch

- One Form C Electrically Held Relay

The RB204 Unit is an A10 enhanced 240 VAC, 50/60 Hz powerline carrier receiver controlling a single remote Form C Relay capable of switching a 30 amp load.

The RB204 will continuously monitor the powerline for PCC signals, and adjust its gain to filter out line noise. The RB204 will close or open its relay via Standard or Extended X10 command.

The RB204 may be remote controlled by addressing it by its base address or its sub address, or through groups by the commands ALL LIGHTS ON, ALL LIGHTS OFF, or ALL UNITS OFF. These global commands must be configured.

The RB204 will transmit the current relay status when requested.

The RB204 has an external override input. Two wires connect to this input. When the wires make contact, the relay is turned on. When the wires break contact, the relay is turned off.

The RB204 also has a mode switch to allow the  user to gain manual control of the relay. ON position turns the relay on, OFF position turns the relay off and AUTO position allows the software to control the relay.

The RB204 may also be configured to remember its relay state upon power up.

The RB104 may be configured with a “time-out” feature, where the state the relay reverts to ON or OFF after a specified period of time. Manufactured under Advanced Control Technologies, Inc.’s U.S. Patent No. 6,229,432. .